Product Description
Our HF High Flow Multistage pump are suitable for domestic, industrial and commercial water boosting, rainwater harvesting, surface irrigation, tank transfer.
Pumped liquid: Clean cold water without abrasives or solids.
Self priming centrifugal jet pump with or without electronic pressure control, single or 3 phase. For submerged, underground or surface mounting. Main flanges in brass for extra longevity and durability against heat/frost.
Automatic version includes pressure control, anti-blocking system, leak detection, and dry run protection with automatic restart.
Available with 1.5hp, motors.
Water cooled, single stage impeller/diffuser with venturi. Supplied with 10m cable.
Spec- Pump Body – Stainless 304
- Motor Body – Stainless 304
- Rotor Shaft – Stainless 420
- Supporting Flanges – Brass
- Impeller, Diffuser and Venturi – Noryl
- Electrical cover – Stainless 304
- Mechanical Seal – Ceramic/Graphite
- Other Seals – NBR70
- Pumped liquid: Clean cold water without abrasives or solids.
- Motor: 1.5hp.
- Inlet Size: 1.25"
- Outlet Size: 1.25"
- Dimensions: 447mm long x 200mm wide x 226mm high
- Weight: 23Kg
- Waterproof protection rating: IP68
- Pump Type: Water cooled, single stage impeller/diffuser with venturi.
- Motor Body: Stainless 304.
- Rotor Shaft: Stainless 420.
- Supporting Flanges: Brass.
- Impeller, Diffuser and Venturi: Noryl.
- Electrical cover: Stainless 304.
- Liquid temperature range: +2°C to +37°C.
- Air temperature: max +45°C.
- Maximum depth: 5m.
- Cable Length: 10m with plug.
- Single phase power input: 230 V 50 Hz
- Manual Start- Requires a Pump Starter
- Mid Curve Performance 4m³ @ 4.5bar
Note: These high flow powerful pumps require installation on a single spur MCB protected. You are strongly advised to consult or have the pump installed by a professional electrician. For the avoidance of doubt a 13A plug is not sufficient. You MUST consult the Manual and if in any doubt consult a professional trained Electrician.